Installation Sheet
Reduce-Reuse-Recycle
This product is made primarily of recyclable materials. You can reduce your carbon footprint by recycling
this product at the end of its useful life. Contact your local recycling support center for further recycling
instructions.
WARRANTY
For more eective and safer operation and to
prolong the life of the heater, read the Owner’s
Guide and follow the instructions. Failure to prop-
erly maintain the heater will void any warranty and
may cause the heater to function improperly.
LIMITED SEVEN YEAR WARRANTY: Manufac-
turer will repair or replace any Hydronic Base-
board (EBHN) heater found to be defective within
seven years after the date of purchase.
These warranties do not apply:
1. Damage occurs to the product through improper
installation or incorrect supply voltage;
2. Damage occurs to the product through
improper maintenance, misuse, abuse, accident,
or alteration;
3. The use of unauthorized accessories or
unauthorized components constitutes an
alteration and voids all warranties. Refer to
Manufacturer’s website or call customer service
at 888.346.7539 for list of authorized accessories
and components.
4. Manufacturer’s warranty is limited to repair or
replacement.
5. In the event Manufcturer elects to replace any
part of your product, the replacement parts are
subject to the same warranties as the product.
The installation of replacement parts does not
modify or extend the underlying warranties.
Replacement or repair of any product or part does
not create any new warranties.
If you believe your product is defective, please
contact Manufacturer during the warranty period,
for instructions on how to have the repair or
replacement processed.
Parts and Service
Visit gdaheat.com/parts for information on where
to obtain parts and service.
How to operate your heater
The room temperature is controlled by a thermostat located either on the wall, or on the heater.
Once installation is complete and power has been restored, follow the steps below for your
thermostat.
If you have a wall or built-in thermostat with a knob:
1. Turn the thermostat knob all the way to the right.
2. When the room reaches your comfort level, turn the knob to the left, just until it clicks and the
heater turns o. The heater will automatically keep the room temperature around this setting.
3. To reduce the room temperature, turn the knob to the left. To increase the room temperature,
turn the knob to the right.
If you have an electronic thermostat, follow the instructions in the programming and operating guide
included with your thermostat.
To register your product, visit gdaheat.com/register
1. Make sure all wires are properly
connected and your heater is
installed before you turn it on.
2. Do not tamper with the high-
temperature safety shuto.
7
The hydronic baseboard uid is a non-toxic mineral oil. No special rst aid measures are needed if
the uid is swallowed, inhaled, or if it gets on your skin or in eyes; simply rinse or wash with soap
and water.
The uid does not freeze.
If the uid leaks, stop using the heater. Cleanup is the same as it is for used oil. Wipe up any leaking
uid with a rag or paper towel. Dispose of uid at a recycling center that accepts used oil. Wash
hands with soap and water.
For more information you can view the Safety Data Sheet here: gdaheat.com
PLEASE NOTE: On initial start-up, the heater may cause an odor due to the manufacturing
process. It typically goes away within several hours.
OPERATING INSTRUCTIONS