Installation Guide

ManualsBrandsCadet Heaters ManualsThermostats KitsCadet Double Pole Field Mount Thermostat Kit for Register Plus Wall Heaters

cadetheat.com Tel: 360-693-2505 PO Box 1675 Vancouver, WA 98668-1675

Benets You Can Depend On

SAVE THESE INSTRUCTIONS

RMT2 Built-In Thermostat Kit

Installation Instructions

IMPORTANT

Wiring Diagram

MANUAL RESET

HIGH TEMP CUTOFF

YELLOW

BLUELOWER ELEMENT

UPPER ELEMENT

WALL

THERMOSTAT

(not provided)

L1 L2

RED RED

MOTOR

TOOLS REQUIRED:

• Phillips Screwdriver

• Needle Nose Pliers

• Double-pole thermostat kit for optional, built-

in control of your Cadet Register heater

• Offers a 3° to 5° comfort range

• Easy-to-use adjustable dial

• Use with Cadet 120-, 208- or 240-volt model

• 4-wire connection for easy installation and

positive off setting

• 25 Amp

• Your RMT2 built-in thermostat is guaranteed

with a 1 year limited warranty

1. Read all instructions before installing or using

this thermostat.

2. High temperatures may be generated under

certain abnormal conditions. Do not partially or

fully cover or obstruct the front of this heater.

3. Do not operate any heater after it malfunctions.

Disconnect power at service panel and have

heater inspected by a qualied electrician before

reusing.

4. To disconnect heater, turn controls to off, and

turn off power to heater circuit at main disconnect

panel.

5. Do not insert or allow foreign objects to enter

any ventilation or exhaust opening as this may

cause an electric shock or re, or damage the

heater.

6. To prevent a possible re, do not block air

intakes or exhaust in any manner.

7. A heater has hot and arcing or sparking parts

inside. Do not use it in areas where gasoline,

paint, or ammable vapors or liquids are used or

stored.

8. Do not use outdoors.

When using electrical appliances, basic precautions should always be followed to reduce the risk of re,

electric shock, and injury to persons, including the following:

http://www.cadetheat.com/products/wall-heaters/register-plus

KIT INCLUDES:

• Mounting Bracket/

Thermostat Assembly

• Knob

• #8 Screw (⅜")

• Thermostat Face Plate

RMT2

Bracket with

Thermostat

Assembly

Page 1

Double

pole built-in

or wall

thermostat

Summary of content (2 pages)

PAGE 1
RMT2 Built-In Thermostat Kit Installation Instructions Benefits You Can Depend On http://www.cadetheat.
PAGE 2
INSTALLATION INSTRUCTIONS 1. All electrical work and materials must comply with the National Electric Code (NEC), the Occupational Safety and Health Act (OSHA), and all state and local codes. 2. Use copper conductors only. 1. Read your Register heater instructions for safety information and how to install heater. Set the heater assembly, blower wheel first, into the left side of the wall can. Fasten at top with screw provided. 2. Connect the two black thermostat wires to the two heater wires.