Owner's Guide

TOOLS REQUIRED
Tape Measure
Straight and Phillips
Screwdrivers1½" Wood ScrewsWire Strippers Wire Connectors
½" Cable Clamp
Connector
Volt Meter
Drill and Drill Bits
Stud Finder
A multi-purpose tool or something to cut your existing drywall or gypsum board.
®
®
®
®
®
®
Hammer
®
®
®
®
INSTALLATION INSTRUCTIONS
1. All electrical work and materials
must comply with the National Elec-
tric Code (NEC), the Occupational
Safety and Health Act (OSHA), and
all state and local codes.
2. Use copper conductors only.
3. DO NOT install the heater directly
above bathtub or sink. DO NOT
install in shower stall area. Cadet
recommends installing your heater at
least 2 feet (61 cm) away to prevent
contact with water.
4. Heater must be connected to a
GFCI protected branch circuit when
installed in a bathroom.
5. Heater must be installed in a wall
can:
Model CE - wall can model CC or
CCSM
6. DO NOT install the heater in a floor,
in the ceiling, below a towel bar,
behind a door, or anywhere the air
discharge may be blocked in any
manner.
7. To reduce the risk of fire, do not store
or use gasoline or other flammable
vapors and liquids in the vicinity of
the heater.
8. Connect grounding lead to grounding
screw provided. Keep all foreign
objects out of heater.
9. Electric heaters must be installed on
a circuit dedicated to electric heaters,
they cannot share a circuit with
outlets, lights, or other appliances.
PARTS OF YOUR HEATER
Model:
Volts:
Watts:
WARNING! TO AVOID ELECTRICAL SHOCK Disconnect power at circuit breaker before servicing. Do not operate without grill.
cadetheat.com Vancouver, WA
Mfg Date:
Before pushing RESET button see Owner’s Guide for display fault codes and other troubleshooting information.
3108579
conforms
to UL STD
2021
072xxx
73
built-in digital
thermostat
heater element
fan and
motor
high-temperature
safety shutoff
3