User manual

22
PROBLEM
No sparks
appear at any
electrodes when
ignition switch is
pushed; noise
can be heard
from spark
module.
Sparks are pres-
ent, but not at all
electrodes
and/or not at full
strength.
POSSIBLE CAUSE
Output lead connec-
tions not completed.
Output lead connec-
tions not complete.
Arcing to grill away
from burner(s).
Weak battery.
Electrodes are wet.
Electrodes cracked or
broken “sparks at
crack”.
CHECK PROCEDURE
Are output connections
on and tight?
Are output connections
on and tight?
If possible, observe grill
in dark location. Operate
ignition system and look
for arcing between out-
put wires and grill
flames.
All sparks present but
weak or at slow rate.
Has moisture accumu-
lated on electrode
and/or in burner ports?
Inspect electrodes for
cracks.
PREVENTION/SOLUTION
Remove and reconnect all
output connections at module
and electrodes.
Remove and reconnect all
output connections at module
and electrodes.
If sparks are observed other
than from burner(s), wire insu-
lation may be damaged.
Replace wires.
Replace battery with a new
AA-size battery.
Use paper towel to remove
moisture.
Replace cracked or broken
electrodes.
TROUBLESHOOTING - ELECTRONIC IGNITION