User's Manual
Table Of Contents
- _
- Cadent, OrthoCAD, iTero, EID-1, EID-1 Optical Impression Device, EID2, EID-2 Optical Impression Device, OrthoCAD iQ, OrthoCAD Set-Up, OrthoCAD Bracket Placement and OrthoCAD Bracket Placement Video System are trademarks or registered trademarks of Cadent.
- Cadent, OrthoCAD, iTero, EID-1, EID-1 Optical Impression Device, EID2, EID-2 Optical Impression Device, OrthoCAD iQ, OrthoCAD Set-Up, OrthoCAD Bracket Placement and OrthoCAD Bracket Placement Video System are trademarks or registered trademarks of Cadent.
- Cadent, Inc.
- 640 Gotham Parkway
- Carlstadt NJ, 07072-2405 USA
- Phone: (201) 842-0800
- Fax: (201) 842-0850
- Email: info@cadent.biz
- Cadent, Inc.
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
- Chapter 1: Introduction
- Chapter 2: Operating Instructions
- Chapter 3: Cart Features
- Appendix A: Hardware Specifications
EID-2 Optical Impression Device Operation Manual
14 Publication SD08300-A (Rev. 1.05)
Back View of Cart
Main Power Shut Off For Shipping or Storage
When you need to unplug the cart for an extended period of time, perform these steps:
(1) Close all files and applications.
(2) Press the front POWER switch to shut down system.
(3) Unplug power cable from the wall socket.
(4) Press the MAIN POWER SHUT OFF switch on the back of the cart to remove power from
all internal components.
Restoring Power after Shipping or Storage
To restore power, press the MAIN POWER SHUT OFF switch once and the system will beep to
indicate return of power. If the battery backup unit is empty (for example, if the system was
unattended during a power out), a 24-hour recharge period is required to restore full capacity.
Main AC Power Cable
Air Vent
(do not block)
Air Vent
(do not block)