User's Manual
Table Of Contents
- _
- Cadent, OrthoCAD, iTero, EID-1, EID-1 Optical Impression Device, EID2, EID-2 Optical Impression Device, OrthoCAD iQ, OrthoCAD Set-Up, OrthoCAD Bracket Placement and OrthoCAD Bracket Placement Video System are trademarks or registered trademarks of Cadent.
- Cadent, OrthoCAD, iTero, EID-1, EID-1 Optical Impression Device, EID2, EID-2 Optical Impression Device, OrthoCAD iQ, OrthoCAD Set-Up, OrthoCAD Bracket Placement and OrthoCAD Bracket Placement Video System are trademarks or registered trademarks of Cadent.
- Cadent, Inc.
- 640 Gotham Parkway
- Carlstadt NJ, 07072-2405 USA
- Phone: (201) 842-0800
- Fax: (201) 842-0850
- Email: info@cadent.biz
- Cadent, Inc.
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
- Chapter 1: Introduction
- Chapter 2: Operating Instructions
- Chapter 3: Cart Features
- Appendix A: Hardware Specifications
EID-2 Optical Impression Device Operation Manual
12 Publication SD08300-A (Rev. 1.05)
Using the Foot Pedal Unit
USING THE PEDALS
The foot pedal unit contains two pedals for activating the
scanning sequence and responding to screen questions. The
colors of the two foot pedals match the Pedals dialog in the
iTero OFFICE application (right is green, left is red).
LED INDICATOR
Pressing either foot pedal turns on the green LED. The battery needs to be replaced if any of
the following events occur:
Pressing a foot pedal causes the LED to blink (or the LED doesn’t light up at all).
Pressing a foot pedal causes no response within the iTero
software.
A warning appears requesting that the battery be replaced.
REPLACING BATTERY
To change the battery, follow the instructions below.
LED Indicator