User's Manual
Table Of Contents
- _
- Cadent, OrthoCAD, iTero, EID-1, EID-1 Optical Impression Device, EID2, EID-2 Optical Impression Device, OrthoCAD iQ, OrthoCAD Set-Up, OrthoCAD Bracket Placement and OrthoCAD Bracket Placement Video System are trademarks or registered trademarks of Cadent.
- Cadent, OrthoCAD, iTero, EID-1, EID-1 Optical Impression Device, EID2, EID-2 Optical Impression Device, OrthoCAD iQ, OrthoCAD Set-Up, OrthoCAD Bracket Placement and OrthoCAD Bracket Placement Video System are trademarks or registered trademarks of Cadent.
- Cadent, Inc.
- 640 Gotham Parkway
- Carlstadt NJ, 07072-2405 USA
- Phone: (201) 842-0800
- Fax: (201) 842-0850
- Email: info@cadent.biz
- Cadent, Inc.
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
- Chapter 1: Introduction
- Chapter 2: Operating Instructions
- Chapter 3: Cart Features
- Appendix A: Hardware Specifications
Operation Manual EID-2 Optical Impression Device
December 26, 2006 11
Disinfecting Scanner and Replacing Disposable Sleeve
To avoid cross contamination between patients, the scanner must be disinfected and the
disposable plastic sleeve must be replaced.
First use disinfectant wipes to clean the scanner arm, cradle, keyboard and mouse. Then
proceed with the steps below in order to replace the disposable sleeve.
STEP 1
Press firmly on both sides of the disposable
sleeve to release.
STEP 2
Pull the disposable sleeve slowly off the scanner
arm and discard.
STEP 3
Note that as the sleeve is removed, the optical
lens is automatically covered over by a small
metal plate. At this time you may slide on a new
sleeve for the next patient.
WARNING !!
When removing the sleeve, be careful not to
touch the optical lens directly with your fingers.
Touching it may cause damage to the optical
lens.