User's Manual
Table Of Contents
- _
- Cadent, OrthoCAD, iTero, EID-1, EID-1 Optical Impression Device, EID2, EID-2 Optical Impression Device, OrthoCAD iQ, OrthoCAD Set-Up, OrthoCAD Bracket Placement and OrthoCAD Bracket Placement Video System are trademarks or registered trademarks of Cadent.
- Cadent, OrthoCAD, iTero, EID-1, EID-1 Optical Impression Device, EID2, EID-2 Optical Impression Device, OrthoCAD iQ, OrthoCAD Set-Up, OrthoCAD Bracket Placement and OrthoCAD Bracket Placement Video System are trademarks or registered trademarks of Cadent.
- Cadent, Inc.
- 640 Gotham Parkway
- Carlstadt NJ, 07072-2405 USA
- Phone: (201) 842-0800
- Fax: (201) 842-0850
- Email: info@cadent.biz
- Cadent, Inc.
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
- Chapter 1: Introduction
- Chapter 2: Operating Instructions
- Chapter 3: Cleaning and Maintenance
- Appendix A: Hardware Specifications
Operation Manual EID-2 Optical Impression Device
April 18, 2007 3
SYMBOLS
Caution! - Wherever this symbol appears on the device, it is recommended to refer to the
instructions in this Operator’s Guide.
Applied part type B. Any component on which this symbol appears is electric isolation type B.
CLASS 1 LASER COMPLIANCE
FCC COMPLIANCE
This device complies with Part 15 of FCC Rules, and operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause undesired
operation.
FCC Warning
Modifications to the device that are not expressly approved by the manufacturer may void your authority to
operate the device under FCC Rules.
CSA COMPLIANCE
This device complies with the following CSA standard for Canada and the USA:
UL Std No. 60601-1 – Medical Electrical Equipment Part 1: General Requirements for Safety.
Class 1 Laser Product
Thi
s product complies with “21 CFR 1040.10” and “EN 60825
-
1”.