User's Manual
Table Of Contents
- _
- Cadent, OrthoCAD, iTero, EID-1, EID-1 Optical Impression Device, EID2, EID-2 Optical Impression Device, OrthoCAD iQ, OrthoCAD Set-Up, OrthoCAD Bracket Placement and OrthoCAD Bracket Placement Video System are trademarks or registered trademarks of Cadent.
- Cadent, OrthoCAD, iTero, EID-1, EID-1 Optical Impression Device, EID2, EID-2 Optical Impression Device, OrthoCAD iQ, OrthoCAD Set-Up, OrthoCAD Bracket Placement and OrthoCAD Bracket Placement Video System are trademarks or registered trademarks of Cadent.
- Cadent, Inc.
- 640 Gotham Parkway
- Carlstadt NJ, 07072-2405 USA
- Phone: (201) 842-0800
- Fax: (201) 842-0850
- Email: info@cadent.biz
- Cadent, Inc.
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
- Chapter 1: Introduction
- Chapter 2: Operating Instructions
- Chapter 3: Cleaning and Maintenance
- Appendix A: Hardware Specifications
EID-2 Optical Impression Device Operation Manual
14 Publication SD08300-A (Rev. 1.10)
Disinfecting Scanner and Replacing Disposable Sleeve
To avoid cross contamination, it is essential that after each patient you disinfect the scanner and
replace the disposable plastic sleeve. First use disinfectant wipes to clean the scanner arm,
scanner cradle, keyboard and mouse. Then proceed with the steps below to replace the sleeve.
STEP 1
Press firmly on both sides of the disposable
sleeve to release it.
STEP 2
Pull the disposable sleeve slowly off the
scanner arm and discard.
STEP 3
As you remove the disposable sleeve, a protective
metal cover is pulled over the optical surface.
WARNING !!!!
Never touch the optical surface directly with
your fingers, as contact may cause damage.
STEP 4
Gently slide on new sleeve by aligning metal peg
to fit directly into the slot on side of sleeve.
STEP 5
Continue to slide the sleeve slowly onto the
scanner arm until it clicks into place.