User's Manual
Table Of Contents
- _
- Cadent, OrthoCAD, iTero, EID-1, EID-1 Optical Impression Device, EID2, EID-2 Optical Impression Device, OrthoCAD iQ, OrthoCAD Set-Up, OrthoCAD Bracket Placement and OrthoCAD Bracket Placement Video System are trademarks or registered trademarks of Cadent.
- Cadent, OrthoCAD, iTero, EID-1, EID-1 Optical Impression Device, EID2, EID-2 Optical Impression Device, OrthoCAD iQ, OrthoCAD Set-Up, OrthoCAD Bracket Placement and OrthoCAD Bracket Placement Video System are trademarks or registered trademarks of Cadent.
- Cadent, Inc.
- 640 Gotham Parkway
- Carlstadt NJ, 07072-2405 USA
- Phone: (201) 842-0800
- Fax: (201) 842-0850
- Email: info@cadent.biz
- Cadent, Inc.
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
- Chapter 1: Introduction
- Chapter 2: Operating Instructions
- Chapter 3: Cleaning and Maintenance
- Appendix A: Hardware Specifications
EID-2 Optical Impression Device Operation Manual
12 Publication SD08300-A (Rev. 1.10)
Automatic Shutdown
When the cart is unplugged or a power outage occurs, a warning beep will begin. If the system
is left unplugged for several minutes, warning messages will appear on the screen and will also
be heard through the speakers. As the minutes pass, the status of the battery backup unit will
be displayed on the screen. When the battery backup unit is nearly empty (after about 10
minutes), the system will automatically shut down. After an automatic shutdown, it may be
necessary to press the front POWER switch once to “wake up” the system.
Main Power Shut Off Before Shipping or Storage
When you need to unplug the cart for an extended period of time, perform these steps:
(1) Close all files and applications.
(2) Press the front POWER switch to shut down system.
(3) Unplug power cable from the wall socket.
(4) Press the MAIN POWER SHUT OFF switch on the back of the cart to remove power from
all internal components.
Restoring Power After Shipping or Storage
To restore power, press the MAIN POWER SHUT OFF switch once and the system will beep to
indicate return of power. If the battery backup unit is low or empty (for example, if the system
was unattended during a power out), a 24-hour recharge period is required to restore full
capacity.