Installation Guide

Tolls we will need:
Adjustable Wrench
Philips Screwdriver
PULL DOWN KITCHEN FAUCET
INSTALLATION INSTRUCTIONS
Notes before installation:
1.Please check that all components are present.
2.Before installation ensure that all feed lines are clear of debris
and on/off valve is present.
3.Ensure water pressure is between 20-125 PSI(includescombination
of hot and cold feed lines).
4.Picetures in the manual are general in content and may not
represent exactly your purchased faucet. if you are having
difficulties please contact a professional plumber.
5.if you will be away from home for an extended period you should
shut off the main water supply.
Daily maintenance:
1.Use a soft cloth and vinegar to remove hard-water spots.
2.Check aerator(if present) regularly for calcium build up are
when water stream is not optimum.
3.DO NOT use caustic cleaning products as the use will break down
finish and will void the product warranty.
4.Acceptable cleaners include vinegar or mild non-abrasive liquid
detergents.
5.if the water pressure appears to be less than optimum remove,
inspect, clean or replace aerator.
5.Attcah flexible hose to water supply.
HOT
COLD
Kitchen Faucet
Note:Pictures in the manual are general in content and may not represent exactly yourpurchased faucet. If you are having difficulties
please contact a professional plumber.
1.Remove the rubber washer, metal washer and locking
nut from the faucet.
2.Install faucet through center hole.
3.Re-install the rubber washer followed by the metal washer
and lock-nut.Hand tighten then tighten further using a screw
driverto tighten lock-nut screws.
4.Attach the pull-down hose to the outlet tube
and screw on the adapter and tightenfirmly in place.
6.Remove the spray head and turn on faucet for
1-minute to flush debris. Close the handle and
re-assemble spray head.