Shower System Installation Manual
Dual function concealed faucet parts list 12 16 13 15 17 14 1 2 18 5 6 7 3 9 10 11 Description QTY Rouqh-in valve protective cover protective cover 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 cover board diverter handle Hexagonal screw Decorative hat on/off handle Hexagonal screw Allen key Decorative hat cover board shower arm shower head Wall covering handle shower Bracket shower hose Technical drawing of dual function 1/2-14NPT 1/2-14NPT Finish wall Max.80mm 3.151NCH 2200-2500mm 86.61-98.
Technical drawing of drilling size 1. The size of the embedded box that needs to be drilled is 5.3" • 6.7" 170mm 6.7INCH 130mm 5.12INCH m 134m H NC 5.3I 2.The depth of the embedded box is 2.36 • - 3.15" It's better to drill the depth of 2.36"for blank wall Max.80mm 3.15INCH mixer water Min.60mm 2.36INCH Tile surface Hot water cold water wall mixer water Pipe connection I.
The procedure of sealing the wall Use a parallel ruler lo measure the flatness of the embedded box casing and the vertical wall surface.If the wall surface is not flat, ii should be patched to ensure the embedded box casing and vertical wall angle meets al nearty ideal angle of 90, then lay the tile decoration. Install the shower head Tile or wooden surface wall outside the wall ≥25mm 10 INCH Handle shower installation Installation of Rough-in valve 1.Take off the protective panel and cover 2.
