User manual

4.5.5 Off hook mode
“Off hook mode” denes how PSTN simulator must treat an OFF hook even on particular FXS port. Default
value is “Standard”. PSTN simulator will provide a Dial tone and will wait for the called number to be dialed
manually.
PSTN Manager allows following values for the “Off Hook mode”:
Standard Default
Hotline (PLAR) Automatically dials pre-congured phone number assigned in the "Hotline"
led
Do nothing No dial tone will be provided
4.5.6 Input/Output amplication
“Input and Output amplication” denes amplication in dB that will be applied to a signal which comes from/to
a connected telephone set to a particular FXS port.
Default value is: 0.00 dB (no amplication)
PSTN Manager allows following values for the “Input” and “Output” amplication:From -100 dB to + 30dB with
0.01 dB increment
4.5.7 Detect “Flash”
Check button “Detect Flash” turns “ON” detection of the “Flash” event.
”Flash” is an event of pressing a telephone’s hook for a time between “Min and Max Flash on hook time”
dened in Global parameter tab.
4.5.8 Detect Pulse dialing
Turns ON and OFF detection of Pulse dialing
Default is: ON
4.5.9 Detect Tone dialing
Turns ON and OFF detection of Tone dialing
Default is: ON
4.5.10 Allow Incoming Call Waiting
Turns ON and OFF an incoming call notication when called party is engaged in another call.
Called party will hear a Call waiting tone either every 10 seconds or according to a congured cadence if
different value was dened.
Default is: ON
4.5.11 Maximum Interdigit Delay
Maximum interdigit delay denes maximum time allowed between two consecutive dialed digits.
After this timer is expired, simulator considers that destination number was dialed completely and it will
perform a phone table lookup or forward it to a PRI module.
23
User Manual
Public Switched Telephone Network (PSTN) Simulators