Installation guide

POWER INPUT
GND
4 OHM BRIDGED
CH1 CH2
CH3
CH3
CH4
4 OHM
BRIDGED
CH4
REM+12V
FUSES
10
RIGHT SUBWOOFER
MINIMUM IMPEDANCE
4 OHMS
LEFT SUBWOOFER
MINIMUM IMPEDANCE
4 OHMS
When bridging the four channel amplier, make sure that your nal woofer impedance on each bridged channel is no lower than 4 ohms. Set the Crossover mode
switch to Low Pass and begin by setting the crossover frequency control to 100Hz and tuning from there.
4 CHANNEL AMP WITH 4 C HANNEL OUTPUT (CSA 1000.4)
4 CHANNEL AMP BRIDGED TO 2 CHANNELS (CSA 1000.4)