Thank you for purchasing this Momentum Amplifier. Please read this manual carefully before beginning your installation. Should you need technical assistance during or after your installation, please call our technical hot-line at 732 370 5400 between 10:00 AM and 5:00PM EST. WARNING: Use of this amplifier at extreme high volumes for extended periods of time may cause hearing loss and or hearing damage. During periods of prolonged high volume levels it is recommended that you use ear safety devices.
INSTALLATION DIRECTIONS The power connections can accept 8 to 10 gauge wire. Be sure to strip just enough wire that fits into the terminal without exposing excess copper. This will protect against shorts from exposed wires which may touch. POWER/GROUND/REMOTE WIRING Connect the amplifier 12V+ connection directly to your car battery using at least 10 gauge primary wire. You should install a secondary inline fuse in the primary wire near the battery connection.
ADJUSTING YOUR SYSTEM. When installing the system, you can not use both the RCA inputs and the High Level Speaker inputs at the same time. You must choose one method or the other. Never run your RCA cables on the same side of the vehicle as your power and ground wires. This will help avoid any electrical noise from getting into your system. It is recommended that you use high quality, shielded RCA cables.
TROUBLE SHOOTING GUIDE Before you power up the system for the first time, please check that all your connections are tight and seated properly. Use a volt meter to check that all equipment is receiving 12Volts and that all grounds are good. Check to make sure that all switches and push buttons are in their proper position. If the amplifier power LED does not light, disconnect all the speakers and RCA connections. Turn the amplifier on again.
