Specifications

Installation and Configuration Activities 35
The following procedure describes how to configure the voice ports.
•
CLEAR_STAT command: To clear the counters for HBER and SYNC, issue the
CLEAR_STAT command. The following example clears the HBER and SYNC
counters for voice port V1A:
VOICE_PORTS V1A CLEAR_STAT
• ONLINE/OFFLINE commands: To turn a voice port online or offline, issue the
ONLINE or OFFLINE command, respectively. When a voice port is offline,
OOS is activated. The following example places voice port V1A offline:
VOICE_PORTS V1A OFFLINE
3.3.5 Configuration Procedure
1. Set signaling (TELCO) parameters for each voice port. For example, enter the
following command:
VOICE_PORTS V1 TELCO E&M 1 NORMAL 4_WIRE
2. If you are using loop-start signaling, select the FXS mode and set the
signaling (TELCO) parameters. For example:
VOICE_PORTS V1 TELCO FXS LOOP_START INTER-RING
Place the DSUB offline* ds of
Configure DSUB framing
format*
ds f DSUB must be offline
Configure DSUB line
code*
ds li DSUB must be offline
Configure DSUB
Channel Associated
Signalling (CAS)*
ds ca DSUB must be offline.
CAS applies to the T-1
DSUB only
Configure DSUB line
build out (LBO)*, or
Configure DSUB
distance*
ds lb DSUB must be offline.
LBO
and Distance apply to the
T-1 DSUB only
ds di
Map digital voice ports to
DS0 channels*
ds m
Place the DSUB online* ds on
Place the data port
online
da dp on
Activate the updated
DSUB background map
with DSUB switch*
ds s
Enable all DLCIs fram dp d dl en Data port must be online
Place all voice ports
online
vvpon
Task Command IBM 9783 Status