Specifications

Command Summary 221
D
LCI TC Format:framdpddltct
Configures the time (t) allocated as Committed Rate
Measurement Interval (tc), onwhich calculation of
the CIR and EIR are based. Time: 10-1000-5000
msec.
DLCI Traffic_
shaping
Format:framdpddltrs
Configures status (s) of traffic shaping on DLCI dl
on frame relay port dp. Status: e(enable) or d
(disable). Frame relay port dp must be online, and
DLCI dl must be created. Default = disable
Line_config
Encoding
Format:framdpliet
Configures the line encoding type (t) used in frame
relay port dp. Type: nrz or nrzi. Frame relay port dp
must be offline.
Line_config
Min_flags
Format:framdplimn
Configures the minimum number of flag bytes (n)
that separate frames sent by frame relay port dp.
Minimum number of flag bytes: 1-15. Frame relay
port dp must be offline.
LMI Error_
threshold
Format:framdplmern
Sets the number (n) of local management interface
(LMI) errors that will be interpreted as an inactive
device or channel on frame relay port dp. Number:
1-3-10. Frame relay port dp must be offline.
LMI
Event_Monitor
Format:framdplmevn
Sets the number (n) of local management interface
(LMI) events (or successful poll cycles) that define
the user device or channel active. This parameter is
significant only after a device or channel has been
declared inactive. Number: 1-4-10. Frame relay port
dp must be offline.
LMI Full_freq Format:framdplmfn
Sets the polling interval (i) in seconds between local
management interface (LMI) integrity status polls on
frame relay port dp. Interval: 5-10-30. Frame relay
port dp must be offline.
LMI Interval Format:framdplmii
Sets the polling interval (i) in seconds between local
management interface (LMI) integrity status polls on
frame relay port dp. Interval: 5-10-30. Frame relay
port dp must be offline.