Specifications

104 IBM Voice Over Frame Relay Perform Guide
6. To define the Call Processing Rule:
7. To define the Telco Output Rule:
4.2.3.8 Summary of This Sample Configuration
By defining corresponding call processing rules for each voice port, calls can be
made between two voice ports in different IBM 2212s without using an IBM 9783.
Each of these rules must specify the same payload and call processing
subchannels, as well as corresponding payload and call processing DLCIs. When
communicating without an IBM 9783, the node ID field is not used.
The Telco Output Rule specifies the sequence of dial digits to be sent out the
telco port when it is the destination of a call. The sequence is specified as a
combination of the destination and source number dial digits passed during the
call setup, constants, and pause characters.
The Telco Output Rule is analogous to the IBM 9783 Destination Output Rule for
a voice port.
Voice Config>ADD CALL-PROCESSING-RULE
Voice Net [0]? 4
Define Call Processing Rule #1
Destination Type (Local or Remote) [Remote]?
Call Processing DLCI (16 to 1007) [16]?
Payload DLCI (16 to 1007) [16]?
Call Processing Subchannel (4 to 254) [4]?
Payload Subchannel (4 to 254) [4]? 5
Dial Digit Matching Rule Number (0 to 2) [0]? 1
Network Output Rule Number (0 to 2) [0]? 2
Voice Config>ADD CALL-PROCESSING-RULE
Voice Net [0]? 4
Define Call Processing Rule #1
Destination Type (Local or Remote) [Remote]?
Call Processing DLCI (16 to 1007) [16]?
Payload DLCI (16 to 1007) [16]?
Call Processing Subchannel (4 to 254) [4]? 6
Payload Subchannel (4 to 254) [4]? 7
Dial Digit Matching Rule Number (0 to 2) [0]? 2
Network Output Rule Number (0 to 2) [0]? 1
Voice Config>ADD TELCO-OUTPUT-RULE
Define Telco Output Rule #1
Digit 1 : (Source/Destination/Constant/Pause/End) [Destination]?
(1-20) [1]? 4
Digit 2 : (Source/Destination/Constant/Pause/End) [Destination]?
(1-20) [5]?
Digit 3 : (Source/Destination/Constant/Pause/End) [Destination]?
(1-20) [6]?
Digit 4 : (Source/Destination/Constant/Pause/End) [Destination]? e
Voice Config>EXIT
Config (only)>NETWORK 4
Voice 4 Config>SET TELCO-OUTPUT-RULE
Telco Output Rule Number (0 to 1) [0]? 1
Voice 4 Config>