Specifications

CONTROLS, INDICATORS, and TERMINALS
7
11. FRONT CHANNEL HIGH-PASS FREQUENCY
MULTIPLIER
17. LEFT/RIGHT FRONT CHANNEL OUTPUT
TERMINALS
18. REAR CHANNEL OUTPUT LEVEL CONTROL
19. LEFT/RIGHT REAR CHANNEL OUTPUT TERMINALS
20. SUBWOOFER OUTPUT LEVEL CONTROL
21. LEFT/RIGHT SUBWOOFER OUTPUT TERMINALS
22. SUBWOOFER OUTPUT LEVEL REMOTE CONTROL
TERMINAL
12. SUBWOOFER FREQUENCY SELECTOR
13. BASS SHAPER BOOST SWITCH
14. PHASE INVERTER
15. SUBWOOFER STEREO/MONO SWITCH
16. FRONT CHANNEL OUTPUT LEVEL CONTROL
Positioning this switch at the “x20” position changes the range
of selectable crossover frequency for the front channel high-pass
from 25Hz - 400Hz to 500Hz - 8K Hz.
Connect to the front channel amplifier left/right inputs.
Used to adjust the rear channel output signal level.
Connect to the rear channel amplifier left/right inputs.
Used to adjust the subwoofer channel output signal level.
Connect to the subwoofer channel amplifier left/right inputs
Allows you to set the low-pass crossover frequency for the sub-
woofer channel between 25Hz and 400Hz.
When activated this circuit provides a single octave boost of 12dB
at 45Hz to equalize the woofer enclosure.
Placing the switch at the “180” position shifts the subwoofer out-
put’s signal 180° out of phase relative to the front and rear output
signals.
For selection of stereo or mono mode subwoofer output.
For adjusting the front channel output signal level.