User Guide

Viewing Results
269
Configuring Probe Display of Simulation Results
To configure what Probe displays when it is started, select
Probe Setup from the Analysis menu. You are given the
following choices:
• Restore Last Probe Session—This restores the display
characteristics from the last session of Probe.
• Show All Markers—This displays the waveforms at
the points on the schematic that have been marked by
markers.
• Show Selected Markers—This displays the waveforms
only for those points on the schematic where the
markers have been selected.
• None—This displays a blank Probe window, ready for
you to select the traces that you want to add.