User Guide

Chapter 7 Creating and Editing Hierarchical Designs
250
6 Right-click to stop placing parts.
7 Click the Get New Part button to display the Part
Browser dialog box (see 7-245
).
8 Enter
M2N6802 in the Part text box.
9 Click Place & Close.
10 Move the part symbol to the desired location of M2
and click to place the part.
11 Right-click to stop placing parts.
If you want to clean-up your schematic, click each of the
MOSFET device names (M2N6804 and M2N6802) and
move them slightly so that the label does not overlap on
one of the pins.
Drawing the voltage source and specifying the DC voltage
attribute
1 Click the Get New Part button to display the Part
Browser dialog box (see 7-245
).
2 Enter
VSRC in the Part text box.
3 Click Place & Close.
4 Move the symbol to the desired location and click to
place it.
5 Right-click to stop placing parts.
Drawing the two analog ground symbols
1 Click the Get New Part button to display the Part
Browser dialog box (see 7-245
).
2 Enter
AGND in the Part text box.
3 Click OK.
4 Move the symbol to the desired location and click to
place it. Repeat for the second ground symbol.
5 Right-click to stop placing parts.