User Guide

Chapter 7 Creating and Editing Hierarchical Designs
246
6 Enter
CMOSINV in the text box. This changes the value
of the REFDES attribute from HB1 to CMOSINV.
7 Click OK.
Drawing the output load resistor
1 Click the Get New Part button to display the Part
Browser dialog box (see 7-245
).
2 Type
R in the Part field.
3 Click Place & Close.
4 Press C+R to rotate the resistor symbol.
5 Move the resistor symbol to the desired location. Click
to place the symbol.
6 Right-click to stop placing parts.
Placing the analog ground symbols
1 Click the Get New Part button to display the Part
Browser dialog box (see 7-245
).
2 Type
AGND in the Part field.
3 Click Place & Close.
You can place the two grounds so that they connect to
the power source and the load resistor. This negates
having to draw wires between the symbols.
4 Move the ground symbol to the desired locations.
Click to place each symbol.
5 Right-click to stop placing parts.