User Guide

Chapter 4 Creating and Editing Designs
98
Example—Using Auto-Repeat and Auto Naming
Use the following procedure to create part of the drawing
shown in Figure 5 using the Auto-Repeat and Auto
Naming functions.
Placing the bus and part
1 Click the Draw Bus button.
2 Move the pencil-shaped pointer to the location of one
end of the first bus segment. Click to start drawing the
bus.
3 Click at each vertex of the bus. Double-click at the end
of the bus.
4 Type 74273 in the Get Recent Part list box on the
toolbar.
5 Press R.
6 Move the outline pointer to the location of U1 and
double-click to place a single instance of the 74273
part.
Figure 5 Auto Naming for Bus Labels