User Guide

Chapter 4 Creating and Editing Designs
96
4 Select the part from the symbol library.
5 Place the first instance of the part.
6 Press M once to place each subsequent instance of
the same part.
Manually repeating part placements
1 If Auto-Repeat is not enabled, press M to repeat the
last action.
If the last action was placing a part, pressing M
changes the pointer to the symbol outline of the last
part placed.
2 Move the symbol outline to any location on the
schematic and click to place the part.
3 To stop placing the part, do one of the following:
• Double-click to place the last instance of the part.
Figure 4 Placing Resistors with Various Vertical and
Horizontal Offsets
Horiz. Offset 00.00
Vertical Offset 00.30
Horiz. Offset 00.00
Vertical Offset 00.50
Horiz. Offset 00.30
Vertical Offset 00.00
Horiz. Offset 00.50
Vertical Offset 00.100
Note Use 8 an
d
S8 to
enable and disable Auto-Repeat,
respectively. If you do not need to change
the offsets, this is a convenient way to
q
uickly place arrays of parts and wires.