Installation manual

GE Security
g
Segment 4
1 = On: if fail to communicate report is enabled
2 = On: if log full report is enabled
3 = On: if autotest report is enabled
4 = On: if start/end programming report is enabled
5 = On: if end download report is enabled
6 = On: if sensor low battery report is enabled
7 = On: if sensor missing report is enabled
8 = On: if autotest report is enabled ONLY when the system is armed
Segment 5
1 = On: enable lost clock service light
2 =
On: enables Zone Doubling (requires NX-200 Zone Doubling Kit).
3 = On: disables on-board zones
4 = On: will allow two trips on same cross-zone to activate an alarm
5 = On: will not allow zones that are force armed to report bypass
6 = On: enables silent exit option
7 = Reserved
8 = On: switch “summer/wintertime” and vice versa
Segment 6
1 = Reserved
2 = Reserved
3 = On: zone activity monitor in hours (not in days)
4 = Reserved
5 = Reserved
6 = On : disables Clean Me report
7 = Reserved
8 = On: valid user code will reset tamper memory
Segment 7
1-8 Reserved
LOCATION 38 - SWINGER SHUTDOWN COUNT
Location 38 contains the number of trips on a zone before that zone will be automatically
bypassed. Refer to the feature definitions.
) LOCATION 39 - KEYPAD SOUNDER CONTROL (1 segment, feature selection data)
Segment 1
1 =
On: if keypad sounds for “Telephone Line Cut” when the system is
armed
2 = On: if keypad sounds for “Telephone Line Cut” when disarmed
3 = On: if keypad sounds for an AC power failure
4 = On: if keypad sounds when a low battery is detected
5 = On: if keypad sounds during cross zone trip time
6 = On: if keypad sounds for zone and box tampers
7 = Reserved
8 = Expander trouble
NX-4-EUR Installation manual Page 47 08/09/04