Installation manual

GE Security

) LOCATION 25 - ZONES 1-8 CONFIGURATION GROUP (8 segments, numerical data)

Location 25 contains the configuration group (zone type) for zones 1-8. Segment 1 is for

zone 1, and segment 8 is for zone 8. You will find the default configurations in the table

above.

LOCATION 26-36 - RESERVED

General options

LOCATION 37 - SIREN AND SYSTEM SUPERVISION (7 segments, feature selection data)

Location 37 is used to enable various system feature and reporting options.

Segment 1

1 = On: if siren sounds for “Telephone Line Cut” when armed

2 = On: if siren sounds for “Telephone Line Cut” when disarmed

3 = On: if siren blast at arming (pulse)

4 = On: if siren blast at exit expiration (pulse)

5 = On: if siren blast at closing kiss-off (pulse)

6 = On: if siren sounds during a “Cross Zone” verification time

7 = On: if siren sounds for a zone or box tamper

8 =

On: if siren blasts 1 time for keyswitch or wireless arming; 2 times

for disarming

Segment 2

1 =

On: if siren driver should be a voltage output. Off: if on-board siren

driver is enabled

2 = On: if sirens sound for expander trouble

3 =

On: for zones to restore immediately. Off: for zones to restore only

when the siren is off or disarmed

4 =

On: if dynamic battery test is performed at arming. Off: if dynamic

battery test is performed at disarming (See location 40)

5 = On: if battery missing test is performed every 12 seconds

6 = On: if manual bell test is performed during [*]-[4]-[4] test function

7 =

On: if manual communicator test is performed during [*]-[4]-[4] test

function

8 = On: if Box Tamper terminals on the control panel are enabled

Segment 3

1 = On: if box tamper report is enabled

2 = On: if AC fail reporting is enabled

3 = On: if low battery reporting is enabled

4 = On: if Aux. power overcurrent report is enabled

5 = On: if siren supervision report is enabled

6 = On: if restore telephone line cut report is enabled

7 = On: A+B Alarm. Off: cross-zoning

8 = On: if expander trouble reporting is enabled

NX-4-EUR Installation manual Page 46 08/09/04