User Guide

15
SERVICE MENU
The service light will be “on” if the security system requires service. If the service
light
is “on”, press the [U] key followed by the [
2
] key to determine the service
condition. One or more zone lights will illuminate indicating what service(s) is
required. Call your service provider immediately for these problems. Below is a
listing of what each light means in a service condition.
LIGHT PROBLEM
SYSTEM FAULT -
Press the [
1
] key. The
zone light(s) that is
illuminated corresponds to the system fault(s) below:
1
Over Current Fault
2
Siren Trouble
3
Box Tamper
4
Expander Power
5
Expander Low Battery
6
Expander Box Tamper
7
Expander Trouble
8
Reserved
1
Press the [
#
] key to return to the 1 of 8 service lights .
2 ZONE TAMPER -
Press the [
2
] key and the
zone light(s) will
illuminate showing the zone(s) that are tampered. Press the [
#
] key
to return to the 1 of 8
service lights .
3 ZONE LOW BATTERY -
Press the [
3
] key. The
zone light(s) will
illuminate showin
g
which zone(s) has a low battery. This only
applies to wireless zones. Press the [
#
] key to return to the 1 of 8
service lights .
4 ZONE LOSS OF SUPERVISION -
Press the [
4
] key and the
zone
li
g
ht(s) will illuminate showin
g
which zone(s) has loss of
supervision. This only applies to wireless zones. Press [
#
] key to
return to the 1 of 8
service lights .
5 ZONE TROUBLE -
Press the [
5
] key and the
zone light(s) will
illuminate showing which zone(s) has a trouble condition. Press the
[
#
] key to return to the 1 of 8
service lights .
6 RESERVED
.
7 FAILURE TO COMMUNICATE -
This light will illuminate when there
is a failure to communicate between your system and the central
station.
8 LOSS OF SYSTEM TIME
- This light will illuminate when there has
been a loss of power and your system clock needs to be reset.
Instructions are on page 13.
EXIT
Press the [
#
] key to exit the Service Light mode.