User Guide

11
ASSIGNING USER CODE AUTHORITY LEVELS
Assign authority levels to users by following the steps below. Assign user codes
before assigning authority levels.
Step 1 Press [U]-[
6
].
Step 2 Enter a “Master Arm/Disarm Code”.
Step 3 The
ready light will flash.
Step 4 Enter the 2 digit “user number” to be assigned authority (always 2
digits such as 03 for user 3). The
ready light is constant and the
instant light will flash.
Step 5 Lights illuminated indicate the authority levels assigned to this code.
An explanation of the lights is listed below. You may toggle (turn
on/off) the authority level by pressing the number for that authority
level.
LIGHT AUTHORITY LEVELS IF LIGHT 8 IS OFF
1
Reserved (
Note: Do not change if on.)
2
Arm Only
3
Arm Only After Closing Time
4
Master Arm/Disarm (can program other codes)
5
Arm/Disarm
6
Bypass Zones
7
Open / Close Reporting
8
If this light is on, this code is programmed as a
function code. Do not change! Press [#] - [#] to
exit.
Step 6 Press [U] [U].
This returns you to Step 3 above. At this point you may enter
another user number to assign authority level. Repeat Steps 4 - 6
until you have assigned authority levels to all user numbers.
Step 7 Press the [#] key to exit the Assigning Authority Level Program.