User's Manual

10
1
9
2
3
4
8
76
5
T Band 902-928MHz
CH MHz
0 903.250
1 903.825
2 904.875
3 905.325
4 905.975
5 906.575
6 907.225
7 908.425
8 909.075
9 910.875
A 911.325
B 916.850
C 925.000
D 925.650
E 926.850
F 927.650
3
6
1. Antennas
2. LCD display
3. IR Node
4. Battery compartment
5. Power switch and volume control
6. Earphone jack
7. Line out jack
8. Belt clip
9. RF Signal indicator
10. Low battery indicator
(ashes when low)
Bodypack GXLIEMBP Receiver
1. Apply power and press the power switch. The following screen
appears at power up.
Fb = Frequency Band
90 = 902 - 928MHz
POWE R
Operating Instructions/System Setup
2. Default display shows current transmitting channel.
Setting the transmitter frequency
3. Channel adjustment. A long press of the UP and DOWN button
unlocks channel adjustment.
When the channel numbers are
ashing, press the UP or DOWN
button to select a channel.
Should you need to temporarily turn off the transmitter
Transmitter power enable/disable.
Transmitter power can be
temporarily disabled by holding
the DOWN and UP buttons for more
than 3 seconds until the screen to
the right appears. To enable, hold
both the DOWN and UP buttons
at the same time until default interface appears.
Setting the bodypack receiver frequency
4. ScanLink™ is enabled by pressing
the DOWN and UP buttons
simultaneously for one second.
Hold the receiver ScanLink interface
towards the ashing LED to set
receiver frequency.
ScanLink
IR