User's Manual

4 5
Specications TXIEM
Transmitting Frequency 520.000 - 538.950 MHz
Frequency Response ................................................................40Hz – 16KHz
Transmitting Power.........................................................................0.132mW
Modulation ................................................................................................ FM
Maximum input level ........................................................................+20dBV
Dynamic Range ................................................................................ >101dBA
Power Requirements ..................................................... 12 - 18VDC, 300mA
Dimensions .................................................8-3/8" [21.2cm] x 3-3/4" [9.5cm]
x 1-3/4" [4.4cm]
Net Weight .............................................................................. 1lb 4oz [.55Kg]
Specications MEB2 In-ear Monitors
Operating Principle .........................................Balanced Armature dynamic
Sensitivity ................................................................................. 142dB@1mW
Impedance ................................................................................................ 22Ω
8 of the channels can be used at any one time if optimal atmospheric
conditions exist.
CH 1 , CH 2, CH 4, CH 8, CH 10, CH 14, CH 15 and CH 16 are
recommended for simultaneous usage.
*These frequencies have been approved for use within the United
States and Canada as of the date of publication of this manual. It is the
user’s responsibility to comply with local regulations.
**These frequencies have been approved for use within the United
States, Canada and Australia as of the date of publication of this
manual. It is the user’s responsibility to comply with local regulations.
CH MHz
1 520.000
2 521.050
3 522.300
4 523.000
5 523.750
6 524.550
7 525.450
8 526.300
9 527.300
10 528.500
11 529.900
12 531.900
13 533.800
14 535.100
15 536.600
16 538.950
§ 15.19 Labelling requirements.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
condition that this device does not cause harmful interference.
§ 15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
§ 15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
* RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The device
can be used in portable exposure condition without restriction.