User Manual

72
20. Troubleshooting
Before reading this section, ensure that the
Cactus V6 transceiver have been set up
c o r r e c t l y (fo l l o w i n g t h e i n s t r u cti o n i n
Section 8-14 of this manual). If the problem
persists after conducting the
troubleshooting steps, contact your seller
directly for further assistance.
1. Wrong Flash Power Fired
LCD DISPLAY POSSIBLE CAUSE SOLUTION
RX displays
wrong power
levels
More than one
TXs are
controlling the
 a s h p o w e r o f
the RXs
- Always use ONE
TX only in a
set up
- Set all
transceivers to
another channel
RX displays
correct
power levels
1. The chosen
ash prof ile
does not match
t h e  a s h m o d e l
Choose the correct
ash prof ile or
learn a new one
2. T h e  a s h i s i n
a wrong
operation mode
(e.g., M m o d e)
Check and set the
 a s h t o t h e T T L
mode
3. A wrong EV
offset has
been set in
the absolute
power mode
Check and reset
the EV offset of
the group
concerned