User Manual

50
1. Connect the V6 RX to your camera using an
appropriate shutter release cable.
2. Set both the V6 TX and RX to the same
channel. On the V6 TX, activate the group
assigned to the V6 RX.
3. Half-press on the TX to test the
auto focus. The status LED on both the
TX and RX will turn ORANGE to indicate
auto focus. Press completely on the
TX for shutter release. The status LED
on both transceivers will turn GREEN to
indicate shutter release.
1. Set the camera to Bulb.
2. Press completely and hold on the V6
TX. The status LED on the V6 TX and V6 RX
will turn green at f irst and go off after
approximately 2 seconds. The LCD display
w i ll s h o w <B U L B M O D E O N >.
3. Release on the V6 TX. The camera’s
shutter is now in a continuous open
state.
4. To close the camera’s shutter, press
completely and release on the V6 TX
again. The green status LED on both the
TX and RX will blink simultaneously.
13.2
Bulb
Mode