User Manual

45
W h e n y o u s e t a l l  a s h es t o 1 1 E V (s e e
italicized section in the above table) in
absolute power mode, all ashes will emit
the same intensity of light notwithstanding
the differences in their own relative power
sca le. For instance, at 11 EV, Flash A is
f iring the amount of light equal to its 1/16
power, while Flash C is f iring equal to its
1/8 power.
To change the V6 system to the absolute
power mode:
1. Switch on the remote V6 in RX mode.
Choose the correct ash prof iles for
each of the V6 RXs.
2. Switch on the V6 that you would like to
be the commander in TX mode. Make sure
that it is on the same channel as the RX
units. Press . Turn the selection dial
to <POWER MODE> and press . Turn the
s el e c tio n d i a l t o < A B S OL U T E (S E T U P)> a n d
press to conf irm.
3. The V6 TX will then collect the ash
prof iles from the V6 RX units and set up
the absolute power level scheme. Once the
set up is f inished, the LCD display will
return to the main screen again and show