User Manual

37
11. Flash Triggering
To command the ash units in different
groups to f ire:
1. Set the V6 transceivers to the correct
mode (transmitter to “TX”, receiver to
“RX”). This will automatically power on
the transceivers (see Section 9.4).
2. Set both TX and RX to the same channel
(s e e S e cti o n 9.5).
3. Assign RX unit(s) to A, B, C, or D group
a n d a c t iv a t e t h e g r o u p(s) o n t h e T X (s e e
S e cti o n 9.6).
4. Connect the V6 RX to portable ashes or
studio strobes.
5. On the TX, press completely. The
status LED of both TX and RX should blink
in green simultaneously. The portable
ashes or studio strobes will f ire at the
same time.
6. Test f ire a particular group by pressing
the group button and completely and
simultaneously.
7. Attach the TX to the camera’s hot shoe.
If your camera does not have a hot shoe,
connect the TX to the camera using an
o pti o n a l P C s y n c c a b l e (C A -20 0).