User Manual

36
3. Switch on the V6 destination unit(s) in
RX mode. Press , and turn the
s el e c tio n d i a l t o < F L A S H S E T U P >. P r e s s
a n d t u r n t h e d i a l t o < C OP Y PR O F I L E >.
Press . The LCD screen will show
<WAITING FOR TX>.
4. On the V6 source unit, press to
conf irm <GO>.
5. The V6 units will start copying the ash
prof iles.
6. When the ash prof iles are all copied
to the V6 destination units, the source
V6 u n it w i ll s h o w <F I N I S H E D S E N DI N G >
while the destination V6 units will show
<F I N IS H E D C O P Y I N G > o n t h e L C D s c r e e n . Yo u
may then leave the menu.
Note:
If identical ash prof iles are found in
both the source V6 and destination V6,
they will not be copied. For non-identical
prof iles that come with the same
prof ile name, they will still be copied
but the last letter of the newly added
prof ile names will be modif ied.