User Manual

35
Notes:
1. Not all ash prof iles can be learned by
the V6 even though they might fulf ill
the requirements provided in
S e c ti o n 7.1.3.
2. Always install fresh batteries to the
ash when starting the ash prof ile
learning.
Once you have f inished learning a number of
ash prof iles with one V6, you may copy all
the custom ash prof iles to other V6 units.
1. Set all the V6 units to the same channel.
2. Pick out the V6 source unit containing
all the learned ash prof iles that you
wish to copy to other V6 units. Switch
it on in TX mode. Press , and turn the
selection dial until the LCD shows <COPY
FLASH SETUP>. Press , and turn the
selection dial to <START>. Press
again. The LCD screen will then show
<S E T R X T O C O P Y P R OF I L E > w it h a n o ptio n
<G O >.
10.3
Copying
Custom
Flash
Profiles