User Manual

32
3. Press and then turn the selection
dial to <FLASH SETUP>. Press .
4. Turn the selection dial to <START
LEARNING>. Press again.
5. Choose the correct ash system.
Press .
6. The LCD screen will show <SET FLASH TO
T T L M O D E >, w it h t h e o p t i o n <G O> b ei n g
selected.
7. Set your ash to the TTL mode and the
maximum zoom level. Press .
8. The V6 will test f ire the ash twice and
determine whether the ash is eligible
fo r t h e  a s h l e a r n i n g p r o g r a m . If t h e
 a s h i s n o t e l i g i b le, t h e L C D s cr e e n w i l l
show <FLASH LEARNING NOT SUPPORTED>.
Tips: There is a chance that the distance
b e t w e e n t h e  a s h a n d t h e r e  e c tiv e s u r f a c e
is too short or too long. Relocate the
ash as specif ied in step 2. Also make
s u r e t h a t y o u h a v e c h o s e n t h e c o r r e c t  a s h
system in step 5.
9. If the ash is eligible for the learning
program, the LCD screen will show <SET
MAX GN> and the default number 45. Turn
the selection dial until the LCD screen