User Manual

30
5. Connect the ash unit to the V6. Switch
y o u r  a s h t o T T L m o d e a n d y o u r  a s h w il l
be ready for remote control. The chosen
ash prof ile will be applied until you
choose another ash prof ile.
In case you wish to f ire and control an
on-camera master ash via the V6 TX, follow
steps 2-4 above in TX mode to choose the
appropriate ash prof ile for the master
ash.
Note:
Once the ash prof ile has taken control of
t h e  a s h, it m a y lo c k u p t h e c o nt r ol p a n el
of s o m e N i k o n  a s h m o d e l s. If y o u w is h t o
a d ju st t h e s e tti n g o n y o u r  a s h w h i l e
connected to the V6, you may unlock the
ash temporarily.
In RX mode, press and hold
for
2 s e c o n d s. T h e L C D s cr e e n w il l s h o w < F L A S H
U N L O C K E D > i n st a ntl y. T h e  a s h w i ll b e
locked again upon subsequent triggering.
In TX mode, press and hold
for
2 seconds, which activates the TTL pass-
through mode. This will also unlock the
ash.