User Manual

29
10. Flash Profile: Choosing,
Learning, and Copying
The V6 transceiver commands ashes to f ire
at a particular output via ash prof iles.
There are three ways to obtain the correct
ash prof iles:
1. Choose from the pre-installed ash
prof iles in the V6.
2. Learn a custom ash prof ile using the V6.
3. Copy the learned prof iles from another
V6.
Choose the appropriate ash prof ile from the
pre-installed prof ile list for each V6 RX
y o u w il l u s e w it h y o u r  a s h.
1. Switch on the V6 in RX mode.
2. Press , and then turn the selection
dial to <CHOOSE PROFILE>. Press .
3. Turn the selection dial until the LCD
s h o w s y o u r  a s h s y s t e m (e.g., < C A N O N >).
Press .
4. Turn the selection dial until the LCD
s h o w s y o u r  a s h m o d e l (e.g., < 5 8 0 E X * >).
Press .
10.1
Choosing
the Flash
Profile
from the
V6