Owner's manual

503/503-P1 Series Industrial Grade SSD Product Manual v2.0Cactus Technologies
®
27
5.1.18. Security Disable Password-F6H
This command checks and removes the Security Mode password.
5.1.19. Sanitize Device-B4H
This command sanitizes all user data on the device. The implementation conforms to ATA/ATAPI
ACS-2 specications. The ATA Sanitize Freeze Lock Ext, ATA Sanitize Status Ext, ATA Sanitize Block
Erase Ext and ATA Sanitize Overwrite Ext commands are supported.
5.1.20. Security Erase Prepare-F3H
This command is issued in preparation for the Security Erase Unit command.
5.1.21. Security Erase Unit-F4H
This command checks the Security Mode password and erases all user data on the device.
5.1.22. Security Freeze Lock-F5H
This command disables further Security Mode commands until the next hardware reset or power
on.
5.1.23. Security Set Password-F1H
This command sets the Security Mode password.
5.1.24. Security Unlock-F2H
This command enables access to a Security Locked device.
5.1.25. Seek-7XH
The Seek command is eectively a NOP command to the drive although it does perform a range
check of cylinder and head or LBA address and returns an error if the address is out of range.
5.1.26. Set Features-EFH
The Set Features command is used by the host to establish or select certain features.
Table 5-12 denes all features that are supported.