User manual

Summit WMScanner Quick Start Guide - Page 14 of 17
Step 9: You can begin taking measurements by clicking on points on the map that correspond to your
current location. There are two options for recording data under the Mode
Mode Mode
Mode section. Single Marker
Single MarkerSingle Marker
Single Marker mode
records a single measurement point on the drawing file when you left click a point on the map. Track Run
Track RunTrack Run
Track Run
mode records multiple points along a straight line which are collected and plotted between your start and
end point clicks. Track runs are continuously drawn unless you switch back to Single Marker
Single MarkerSingle Marker
Single Marker mode. If you
wish to delete a measurement, click on the Undo
UndoUndo
Undo button. For further explanations of these two modes,
please refer to Taking Measurements
Taking MeasurementsTaking Measurements
Taking Measurements in Chapter 3
Chapter 3 Chapter 3
Chapter 3 –
––
– Measurement Surveys
Measurement Surveys Measurement Surveys
Measurement Surveys in the Summit WMScanner
Summit WMScannerSummit WMScanner
Summit WMScanner User
User User
User
Manual
ManualManual
Manual.
Step 10: If you find that you are zoomed too far in or out, click on the
icon. Left click and hold the
mouse button while the cursor is in the drawing window and move the mouse up or down in order to zoom
in or out. When you are done, right click in the drawing window and go to Exit
ExitExit
Exit. To pan the drawing file so
that you can take a measurement in a certain location of the map, click on the
icon. Left click and hold
the mouse button with the cursor in the drawing window. Move the mouse in the direction you wish to pan
to. To exit Pan
PanPan
Pan mode, right click in the drawing window and choose Exit
ExitExit
Exit.
Step 8: When you are done taking measurements, click the Exit
ExitExit
Exit button.