User`s guide

ment measures suitable for transport.

• For questions, defects, mechanical damages, malfunctions, and other functional

problems which cannot be resolved by this guide, please contact your dealer for repair or

replacement, as described in the Chapter “Warranty and Liability”.

• Please observe the maximum bearing loads listed in the Chapter “Specications”.

• Please also observe the terms of use described in the Chapter “Intended Use”.

• The supplied components are only suitable for installation to a solid stone and concrete

ceiling. If the structure of your ceiling is different, corresponding installation material

must be used. In any case, consult a specialist.

5 Note on Waste Disposal:

This product should be not disposed together with domestic waste. Please return your

device free of charge at the end of its service life at public collection points established for

this purpose, or at the sales outlet. Details for disposal are regulated in the relevant federal

state law. Potential recyclable materials are fed into the recycling cycle to obtain new raw

materials from them. Following recyclable materials are collected a local collection points:

• Waste glass, plastic, waste metal, metal sheet, and more.

This type of recycling of waste equipment contributes signicantly to the protection of our

environment.

6 Installation:

ATTENTION! Only trained professionals are authorized to install the device on a

ceiling, and to remove it from there. For more information please read the

Chapters “Notes on Safety” and “Troubleshooting”.

a) Installation of Video or Slide Projector Bracket:

Use screws (17) to attach the mounting arms (5).

Adjust the mounting arms (5) to the same height.

You can chose from Option I, II, or III to adjust the mounting arms to

the same height on the video or slide projector housing.

Slide the mounting arms to the center of the video or slide projector

housing, and use M6 screws (7), washers (11), and (16) to attach

them to the video or slide projector bracket (2). Then, tighten the

screws.

Manual