Use and Care Manual
Cabot
®
Australian Timber Oil
#3400 Series
.The data on this sheet represent typical values. Since application variables are a major factor in product performance, this information should serve only as a general guide. Valspar assumes no obligation or liability for use of this information.
UNLESS VALSPAR AGREES OTHERWISE IN WRITING, VALSPAR MAKES NO WARRANTIES, EXPRESS OR IMPLIED, AND DISCLAIMS ALL IMPLIED WARRANTIES INCLUDING WARRANTIES OF MERCHANTABILITY OR FITNESS
FOR A PARTICULAR USE OR FREEDOM FROM PATENT INFRINGEMENT. VALSPAR WILL NOT BE LIABLE FOR ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES. Your only remedy for any defect in this product is the
replacement of the defective product, or a refund of its purchase price, at our option.
The data on this sheet represent typical values. Since application variables are a major factor in product performance, this information should serve only as a general guide. CABOT assumes no obligation or liability for use of this information. UNLESS CABOT
AGREES OTHERWISE IN WRITING, CABOT MAKES NO WARRANTIES, EXPRESS OR IMPLIED, AND DISCLAIMS ALL IMPLIED WARRANTIES INCLUDING WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR USE OR FREEDOM
FROM PATENT INFRINGEMENT. CABOT WILL NOT BE LIABLE FOR ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES. Your only remedy for any defect in this product is the replacement of the defective product, or a refund of its purchase
price, at our option.
TECHNICAL DATA
Pigment Type: Trans-oxide/iron oxide pigments,
titanium dioxide.
Vehicle Type: Long-oil alkyds, tung oil and
natural linseed oil.
Solvent: Aliphatic petroleum distillates
Viscosity: 26–56 seconds, Centipoise
Flash Point: over 100°F
V.O.C. Content: < 550 g/L
Solids Weight: 40%
Solids Volume: 34%
Pigment Weight: 1.9%
Density: 7.3 lbs./gal.
Film Thickness: Minimal because Cabot
Australian Timber Oil penetrates deeply into
wood.
Water Repellent: Yes
Mildew Resistant: Yes
*Data reported is typical of the Neutral Base and will
vary by color and batch.
REGULATORY COMPLIANCE
Current as of: 4/14/2015
SCAQMD No
CARB 2000 SCM No
CARB 2007 SCM No
OTC/LADCO No
US National Yes
PACKAGING
Neutral Base available in quart, gallon and 5
gallon sizes, ready mix colors available in gallon.
BASE AND FILL LEVELS
(oz./gal.)
Neutral (3400)
Mahogany Flame (3459)
Jarrah Brown (3460)
128
128
128
CLEANUP AND DISPOSAL
Clean up with mineral spirits or VOC compliant
brush cleaner. Keep container closed when not in
use. Do not transfer contents to other containers
for storage or disposal. In case of spills, absorb
with inert material such as sand or kitty litter.
Dispose of empty container or unused portion in
accordance with local, state and federal
regulations.
DANGER: Rags, steel wool or waste soaked
with this product may spontaneously catch
fire if improperly discarded. Immediately after
use, place rags, steel wool or waste in a
sealed, water-filled metal container. Dispose of
according to local regulations.
WARRANTY
If this product does not perform as stated on the
label after you apply it according to label
directions, Cabot will either replace this product or
refund its purchase price, at its option. Cabot
disclaims all other implied or expressed
warranties. Cabot will not provide or pay for labor
for removal or application of the product. This
warranty excludes all incidental or consequential
damages. This warranty gives you specific legal
rights, and you may have other rights which vary
from state to state.
CAUTIONS
DANGER! Contains Petroleum Distillates and
Crystalline Silica. KEEP OUT OF THE REACH
OF CHILDREN. May affect the brain or nervous
system causing dizziness, headache or nausea.
Causes eye, skin, nose and throat irritation. Use
only with adequate ventilation. Keep away from
heat, sparks and flame. Avoid breathing vapors,
spray mist or sanding dust. If painting indoors,
open windows and doors or use other means to
ensure fresh air entry during application and
drying. If you experience eye watering, headache
or dizziness, or if air monitoring demonstrates
vapor/mist levels are above applicable limits, wear
an appropriate, properly fitted respirator (NIOSH
approved) during and after application. Follow
respirator manufacturer’s directions for respirator
use. When sanding, wear a dust mask. Avoid
contact with the eyes and skin. Wash thoroughly
after handling. Close container after each use. DO
NOT TAKE INTERNALLY. NOTICE: Reports of
commercial painters have associated repeated
and prolonged occupational overexposure to
solvents with permanent brain and nervous
system damage. Intentional misuse by
deliberately concentrating and inhaling the vapors
may be harmful or fatal. Delayed effect from long-
term exposure: Cancer hazard. Contains
crystalline silica, which can cause cancer. Risk
depends upon duration and level of exposure to
dust generated from sanding surfaces or spray
mist. WARNING: This product contains a chemical
known to the State of California to cause cancer.
First Aid: Eye Contact: Flush thoroughly with
water for at least 15 minutes. If irritation persists,
get medical attention.* If Inhaled: If affected by
vapor or spray mist, move to fresh air. If breathing
difficulty continues, get medical attention.* If
Swallowed: Do not induce vomiting. Get medical
attention immediately.*
* Call poison control center, hospital emergency
room or physician immediately
CS 6.3 HQG
For additional safety and chronic health hazard
information, refer to the Material Safety Data
Sheet for this product.
EMERGENCY MEDICAL TELEPHONE:
1-888-345-5732
8725 W. Higgins Rd., Chicago, IL 60631
800-US-STAIN
cabotstain.com
Revised: 4/14/15
Version: 3400G