User Manual

Configuring OSPF
184 Enterasys X-Pedition User Reference Manual
The following is a table of the port types and the OSPF default cost associated with each type:
Table 10. OSPF Default Cost Per Port Type
To configure OSPF interface parameters, enter one of the following commands in Configure mode:
Port Media Type Speed OSPF Default Cost
Ethernet 1000 1000 Mbps 2
Ethernet 10/100 100 Mbps 20
Ethernet 10/100 10 Mbps 200
WAN (T1) 1.5 Mbps 1333
WAN (T3) 45 Mbps 44
Enable OSPF state on interface.
ospf set interface <name-or-IPaddr>|all state
disable|enable
Specify the cost of sending a packet on an
OSPF interface.
ospf set interface <name-or-IPaddr>|all cost
<num>
Specify the priority for determining the
designated router on an OSPF interface.
ospf set interface <name-or-IPaddr>|all priority
<num>
Specify the interval between OSPF hello
packets on an OSPF interface.
ospf set interface <name-or-IPaddr>|all hello-
interval
<num>
Configure the retransmission interval
between link state advertisements for
adjacencies belonging to an OSPF
interface.
ospf set interface <name-or-IPaddr>|all retransmit-
interval
<num>
Specify the number of seconds required to
transmit a link state update on an OSPF
interface.
ospf set interface <name-or-IPaddr>|all transit-
delay
<num>
Specify the time a neighbor router will
listen for OSPF hello packets before
declaring the router down.
ospf set interface <name-or-IPaddr>|all router-
dead-interval
<num>
Disable IP multicast for sending OSPF
packets to neighbors on an OSPF
interface.
ospf set interface <name-or-IPaddr>|all no-
multicast
Specify the poll interval on an OSPF
interface.
ospf set interface <name-or-IPaddr>|all poll-interval
<num>