Specifications

9030992 E6 ConfigurationViews
3-21
Station Alarms Dialog Box
Modifying the Threshold Settings
This button moves all of the stations from the Stations list to the Apply
Settings to list. The current station remains at the top of the Apply Settings to
list if it is a valid station.
This button moves all of the stations from the Apply Settings to list to the
Stations list. The current station remains at the top of the Apply Settings to
list if it is a valid station.
This button applies the threshold settings to the stations listed in the Apply
Settings to list, or the station entered into the Station field if the list is empty.
This button initiates a read of the threshold settings for the selected station,
or the station entered into the Station field.
This button exits the dialog box without applying settings to the stations, or
once you have applied all changes and wish to exit.
Modifying the Threshold Settings
To change the threshold settings for one or more stations, follow these steps:
1. Move the addresses of all the stations to be modified to the Apply Settings
to list. If you are only modifying the current station, this step is not
necessary. If you wish to modify a valid station that does not appear in the
list, enter its MAC address into the Station field. For information on how
to move addresses between lists, refer to the buttons described earlier in
this section.
2. Select the desired settings to be applied to the current station and all
stations in the Apply Settings to list by clicking on Enable or Disable for
each alarm threshold and typing a value into each Threshold field.
3. Click on the Apply button.
If the new alarm thresholds cannot be written to the device, due to the device
being down, an error message appears and you should try again later.
>>
<<
Apply
Read
Cancel