Technical data

9031251 E6 ConÞguration & Station Table Views
3-43
Token Ring Station Table Views
Station Alarms Dialog Box
information on how to move addresses between lists, refer to the button
descriptions in the preceding subsection.
2. Select the desired settings to be applied to the current station and all
stations in the Apply Settings to list by clicking on Enable or Disable
for each alarm threshold, and/or typing any new desiored value into one or
more Threshold Þelds.
3. Click on the Apply button.
If the new alarm thresholds cannot be written to the device, because of the
device being down, the system will display an error message and you should
try again later.
Reading Thresholds from a Station
To read the current threshold settings from any station, proceed as follows:
1. Select the station to be read from the Apply Settings to list, moving the
station address to that list if necessary. If you wish to modify a valid
station that does not appear in either list, enter its MAC address into the
Station Þeld.
2. Click on the Read button. The threshold settings for the selected station
are read from the device, appearing in the applicable Threshold Þelds.