Technical data

9031251 E6 ConÞguration & Station Table Views
3-41
Token Ring Station Table Views
Station Alarms Dialog Box
station tables (in the Token Ring Station Table view, the Token Ring Station
Isolating Errors view, the Token Ring Station Non-Isolating Errors view, the
Token Ring Alarm Thresholds view, or the Token Ring Station Alarm States
view) and then select the Station Alarms button in the lower left corner of the
table.
Station Alarms dialog Box Details
The controls on the Station Alarms dialog box let you modify and/or read the
alarm settings for a single station or for any desired selection of stations on
the ring. (The Stations list initially displays the stations that were on the
ring at the time the dialog box was opened, but you can read and modify the
settings of a valid station that was added to the ring after the view was
opened by entering its address in the Station Þeld.) The Station Alarms
dialog box provides the following information:
Station Ð The address of the current station (initially, the station identiÞed
by whichever line entry was highlighted on the station table in the view from
which you activated the dialog . You can enter the address of any valid station
in this Þeld to make it the current station.
Alarm Ð The threshold alarms that can be manipulated. The alarms in this
column include Line, Internal, Burst, A/C, and Congestion.
Threshold Ð The current setting for each corresponding alarm threshold.
You can change the values by selecting the Þeld and editing the number.
State Ð The state of each corresponding alarm threshold (Enable or
Disable), as determined by whichever mutually exclusive button was last
slelected
Stations Ð The MAC addresses of all stations in the ring at the time the
dialog box was opened, except the current station, which is displayed in the
Apply Settings to list. Double-clicking on an address in this list moves it to the
Apply Settings to list. Alternatively, you can highlight any desired station
address in that list and then click on the > button to move that station address
to the Apply Settings to Þeld.
Apply Settings to Ð The MAC addresses of all stations to which the
threshold settings may be applied. When the dialog box is intially opened, this
list will contain the current stationÕs MAC address, but you can move any
desired combination of addresses from the Stations list to this Þeld. Double-
clicking on an address in this list moves it to the Stations list. Alternatively,
you can highlight any desired station address in this Apply Settings to list
and then click on the < button to move that station address to the Stations
Þeld.