Technical data

Token Ring Station Table Views
Token Ring Non-Isolating Errors Table View
ConÞguration & Station Table Views TRBMIM
3-34 Management Module Guide
Finally, two selection buttons located just above the blocked-off Station Table
area provide respective access to other table views, each of which then leads to
another view:
The Non-Isolating Errors Table button, provided in place of the Isolating
Errors Table button appearing in this same location in the Token Ring Station
Table view, opens the Token Ring Station Non-Isolating Errors Table view,
which is described in Token Ring Non-Isolating Errors Table View, following.
The Alarms Table button is the same as described for the Token Ring Station
Table view. Clicking on this button opens the Token Ring Station Alarm
Thresholds view, which is described in Token Ring Station Alarm Thresholds
View, starting on page 3-35. That view in turn gives access to the Token Ring
Station Alarm States view, which is described on page 3-37.
Token Ring Non-Isolating Errors Table View
Opening the Token Ring Non-Isolating Errors Table View
To open the Token Ring Non-Isolating Errors Table view, click on the Non-
Isolating Errors button in the Token Ring Station Isolating Errors view
(refer to Token Ring Station Isolating Errors Table View Details, starting on
page 3-33).
Token Ring Non-Isolating Errors Table View Details
In addition to the general conÞguration information common to most generic
views, enclosed within the status border in the top part of the view, the Token
Ring Isolating Errors Table view displays the same Ring Name, Ring Number,
Ring Speed, Ring Status, and Active Monitor information as presented in the
Token Ring Station Table view (refer to descriptions of these Þelds on
page 3-29).
The blocked-off Station Non-Isolating Errors Table area in the lower half
of the screen also uses the same tabular setup as the previously described
Token Ring Station Table view and the Token Ring Isolating Errors Table
view. This setup includes the same Station Address and Station Name
columns, the Update, Totals/Deltas, MAC/Canonical, Sort Up/Sort Down/Un-
Sort, and Set/Clear Filter control buttons across the top of the table, and the
same Station Detail, Station Alarms, and Remove Station selection buttons
Non-Isolating Errors Table
Alarms Table