Technical data

TRBMIM Physical Device View
Device View TRBMIM
2-2 Management Module Guide
Only capabilities, in which case the Device View shows only the TRBMIM unit
itself. Figure 2-2 on page 2-5 shows the Physical Device View when the
module has been set for Bridging-and-Management capabilities, in which case
the Device View shows representations not only for the TRBMIM but also for
the associated Hub modules. Similarly, Figure 2-3 on page 2-8 shows the
Logical Device View for the Bridging-Only mode and Figure 2-4 on page 2-9
shows the Logical Device View for the Bridging-and-Management mode.
TRBMIM Physical Device View
The lower part of the Physical Device View (see Figure 2-1 and Figure 2-2)
shows a representation of the actual equipment being modeled Ñ exactly as
you would see them if you were to stand in front of the rack in which they are
mounted. At the present time, the indicator lights of the TRBMIM
components of this program are not implemented; a future revision will
provide near-real-time monitoring of associated signal conditions for those
indicators.
Accessing the Physical Device View
You can access the TRBMIMÕs Physical Device View through any of the
following methods:
1. Double-click on the Device View button of the TRBMIM device icon, as
shown below. This action will open up whichever Device View was last
opened for that device (i.e., Logical or Physical).
Location View Icon
Topology View Icon
Device View Button