Setup guide

MMAC-M5FNB SETUP
Page 3-3
Figure 3-1. Installing the M5FNB into a Rack
3. Insert the screws through the holes on the mounting bracket and
into the screw holes on the MMAC-M5FNB.
4. Tighten the screws until the mounting bracket is securely attached
to the unit.
5. Repeat steps 2-4 for the second rack mount bracket. Be sure to use
the same set of holes on the second rack mount bracket (front for
flush mount, rear for recessed mount) that you used on the first
bracket.
6. Slide the unit into the rack, being sure to leave sufficient room to
install the cable tie tray, if desired.
MMAC-M5FNB
The Complete Networking Solution™
Multi Media Access Center
1
4
3
2
6
5
1.) Screws (8 total; 4 each side)
2.) Rack mount bracket
3.) Holes for flush mount
4.) Holes for recessed mount
5.) Bolts (secure with locking washers)
6.) Equipment rack